Cisco » IOS » 12.3yk : Security Vulnerabilities, CVEs,

Cisco IOS 12.2 through 12.4 before 20060920, as used by Cisco IAD2430, IAD2431, and IAD2432 Integrated Access Devices, the VG224 Analog Phone Gateway, and the MWR 1900 and 1941 Mobile Wireless Edge Routers, is incorrectly identified as supporting DOCSIS, which allows remote attackers to gain read-write access via a hard-coded cable-docsis community string and read or modify arbitrary SNMP variables.

Unspecified vulnerability in the SIP implementation in Cisco IOS 12.3 and 12.4 allows remote attackers to execute arbitrary code via a malformed SIP message, aka Bug ID CSCsz48680, the "SIP Message Processing Arbitrary Code Execution Vulnerability."

Unspecified vulnerability in the SIP implementation in Cisco IOS 12.3 and 12.4 allows remote attackers to execute arbitrary code via a malformed SIP message, aka Bug ID CSCsz89904, the "SIP Packet Parsing Arbitrary Code Execution Vulnerability."

A vulnerability in the Cisco Cluster Management Protocol (CMP) processing code in Cisco IOS and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a reload of an affected device or remotely execute code with elevated privileges. The Cluster Management Protocol utilizes Telnet internally as a signaling and command protocol between cluster members. The vulnerability is due to the combination of two factors: (1) the failure to restrict the use of CMP-specific Telnet options only to internal, local communications between cluster members and instead accept and process such options over any Telnet connection to an affected device; and (2) the incorrect processing of malformed CMP-specific Telnet options. An attacker could exploit this vulnerability by sending malformed CMP-specific Telnet options while establishing a Telnet session with an affected Cisco device configured to accept Telnet connections. An exploit could allow an attacker to execute arbitrary code and obtain full control of the device or cause a reload of the affected device. This affects Catalyst switches, Embedded Service 2020 switches, Enhanced Layer 2 EtherSwitch Service Module, Enhanced Layer 2/3 EtherSwitch Service Module, Gigabit Ethernet Switch Module (CGESM) for HP, IE Industrial Ethernet switches, ME 4924-10GE switch, RF Gateway 10, and SM-X Layer 2/3 EtherSwitch Service Module. Cisco Bug IDs: CSCvd48893.

Cisco IOS 12.0 to 12.4 might allow remote attackers to execute arbitrary code via a heap-based buffer overflow in system timers. NOTE: this issue does not correspond to a specific vulnerability, rather a general weakness that only increases the feasibility of exploitation of any vulnerabilities that might exist. Such design-level weaknesses normally are not included in CVE, so perhaps this issue should be REJECTed.

Stack-based buffer overflow in the Line Printer Daemon (LPD) in Cisco IOS before 12.2(18)SXF11, 12.4(16a), and 12.4(2)T6 allow remote attackers to execute arbitrary code by setting a long hostname on the target system, then causing an error message to be printed, as demonstrated by a telnet session to the LPD from a source port other than 515.

The Simple Network Management Protocol (SNMP) subsystem of Cisco IOS 12.0 through 12.4 and 15.0 through 15.6 and IOS XE 2.2 through 3.17 contains multiple vulnerabilities that could allow an authenticated, remote attacker to remotely execute code on an affected system or cause an affected system to reload. An attacker could exploit these vulnerabilities by sending a crafted SNMP packet to an affected system via IPv4 or IPv6. Only traffic directed to an affected system can be used to exploit these vulnerabilities. The vulnerabilities are due to a buffer overflow condition in the SNMP subsystem of the affected software. The vulnerabilities affect all versions of SNMP: Versions 1, 2c, and 3. To exploit these vulnerabilities via SNMP Version 2c or earlier, the attacker must know the SNMP read-only community string for the affected system. To exploit these vulnerabilities via SNMP Version 3, the attacker must have user credentials for the affected system. All devices that have enabled SNMP and have not explicitly excluded the affected MIBs or OIDs should be considered vulnerable. Cisco Bug IDs: CSCve60376, CSCve78027.

A vulnerability in the web UI of Cisco IOS and Cisco IOS XE Software could allow an unauthenticated, remote attacker to conduct a cross-site request forgery (CSRF) attack on an affected system. The vulnerability is due to insufficient CSRF protections for the web UI on an affected device. An attacker could exploit this vulnerability by persuading a user of the interface to follow a malicious link. A successful exploit could allow the attacker to perform arbitrary actions with the privilege level of the targeted user. If the user has administrative privileges, the attacker could alter the configuration, execute commands, or reload an affected device.

A vulnerability in the FTP application layer gateway (ALG) functionality used by Network Address Translation (NAT), NAT IPv6 to IPv4 (NAT64), and the Zone-Based Policy Firewall (ZBFW) in Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload. The vulnerability is due to a buffer overflow that occurs when an affected device inspects certain FTP traffic. An attacker could exploit this vulnerability by performing a specific FTP transfer through the device. A successful exploit could allow the attacker to cause the device to reload.

Cisco IOS 12.2 through 12.4 and 15.0 through 15.2 and IOS XE 2.1.x through 2.6.x and 3.1.xS before 3.1.2S, 3.2.xS through 3.4.xS before 3.4.2S, 3.5.xS before 3.5.1S, and 3.1.xSG and 3.2.xSG before 3.2.2SG, when AAA authorization is enabled, allow remote authenticated users to bypass intended access restrictions and execute commands via a (1) HTTP or (2) HTTPS session, aka Bug ID CSCtr91106.

Cisco IOS after 12.3(14)T, 12.3(8)YC1, 12.3(8)YG, and 12.4, with voice support and without Session Initiated Protocol (SIP) configured, allows remote attackers to cause a denial of service (crash) by sending a crafted packet to port 5060/UDP.

The SERVICE.DNS signature engine in the Intrusion Prevention System (IPS) in Cisco IOS 12.3 and 12.4 allows remote attackers to cause a denial of service (device crash or hang) via network traffic that triggers unspecified IPS signatures, a different vulnerability than CVE-2008-1447.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4 allows remote attackers to cause a denial of service (device reload) via a crafted Protocol Independent Multicast (PIM) packet.

The SSLVPN feature in Cisco IOS 12.3 through 12.4 allows remote attackers to cause a denial of service (device reload or hang) via a crafted HTTPS packet.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, when configured with (1) IP Service Level Agreements (SLAs) Responder, (2) Session Initiation Protocol (SIP), (3) H.323 Annex E Call Signaling Transport, or (4) Media Gateway Control Protocol (MGCP) allows remote attackers to cause a denial of service (blocked input queue on the inbound interface) via a crafted UDP packet.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, when SIP voice services are enabled, allows remote attackers to cause a denial of service (device crash) via a valid SIP message.

Cisco IOS 12.2 through 12.4 and 15.0 through 15.1, Cisco IOS XE 2.5.x and 2.6.x before 2.6.1, and Cisco Unified Communications Manager (aka CUCM, formerly CallManager) 4.x, 5.x before 5.1(3g), 6.x before 6.1(4), and 7.x before 7.1(2) allow remote attackers to cause a denial of service (device reload or voice-services outage) via a malformed SIP INVITE message that triggers an improper call to the sipSafeStrlen function, aka Bug IDs CSCsz40392 and CSCsz43987.

Unspecified vulnerability in Cisco IOS 12.2 through 12.4 allows remote attackers to cause a denial of service (device reload) via a crafted H.323 packet, aka Bug ID CSCsz38104.

Unspecified vulnerability in Cisco IOS 12.2 through 12.4, when the Cisco Unified Border Element feature is enabled, allows remote attackers to cause a denial of service (device reload) via crafted SIP messages, aka Bug ID CSCsx25880.

Cisco IOS before 15.0(1)XA does not properly handle IRC traffic during a specific time period after an initial reload, which allows remote attackers to cause a denial of service (device reload) via an attempted connection to a certain IRC server, related to a "corrupted magic value," aka Bug ID CSCso05336.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, IOS XE 2.1.x through 2.3.x before 2.3.2, and IOS XR 3.2.x through 3.4.3, when Multiprotocol Label Switching (MPLS) and Label Distribution Protocol (LDP) are enabled, allows remote attackers to cause a denial of service (device reload or process restart) via a crafted LDP packet, aka Bug IDs CSCsz45567 and CSCsj25893.

The IKE implementation in Cisco IOS 12.2 through 12.4 on Cisco 7200 and 7301 routers with VAM2+ allows remote attackers to cause a denial of service (device reload) via a malformed IKE packet, aka Bug ID CSCtb13491.

The SIP implementation in Cisco IOS 12.3 and 12.4 allows remote attackers to cause a denial of service (device reload) via a malformed SIP message, aka Bug ID CSCtb93416, the "SIP Message Handling Denial of Service Vulnerability."

Cisco IOS 12.1 through 12.4, and 15.0M before 15.0(1)M1, allows remote attackers to cause a denial of service (interface queue wedge) via malformed H.323 packets, aka Bug ID CSCta19962.

Cisco IOS 12.1 through 12.4, when Cisco Unified Communications Manager Express (CME) or Cisco Unified Survivable Remote Site Telephony (SRST) is enabled, allows remote attackers to cause a denial of service (device reload) via a malformed Skinny Client Control Protocol (SCCP) message, aka Bug ID CSCsz48614, the "SCCP Packet Processing Denial of Service Vulnerability."